Is Schematic Printing bannable?

[Revioli]

I was banned on the server 3x, The first was 10 mins. then i waited. then i got unbanned.
Then i went to back to use a Schematics again, then i got instantly banned. And now an Hour ban.
then After the hour ban. i went back to use schematics i got banned by console again. Now a 1 day ban.
Although a moderator told us that schematics are allowed. and i see alot of players use it. especially printing.

 

[kaivalya]

Although a moderator told us that schematics are allowed.

Using schematics is allowed on Jartex
i.e. you can use mods which show you a hologram of your build in your world

Although using printer mod or schematica printer mod is not allowed
If you are found using it in factions, your faction gets strike and if you are found using it in gamemodes like survival you will get banned

for more details refer https://jartexnetwork.com/rules/

and i see alot of players use it. especially printing.

Report them !!! over at https://jartexnetwork.com/forums/gameplay-reports.60/ for "printer" rule break
make sure to get a proper recording of it

I was banned on the server 3x, The first was 10 mins. then i waited. then i got unbanned.
Then i went to back to use a Schematics again, then i got instantly banned. And now an Hour ban.
then After the hour ban. i went back to use schematics i got banned by console again. Now a 1 day ban.

Some of the schematica mods allow you to walk over "the hologram" and its not allowed since its unfair advantage
and this could have been detected by anticheat as flying or similar hacks which is not too far off
But if you getting kicked/banned for no reason repeatedly you could make a bug report over at https://jartexnetwork.com/bug-reports/
Make sure to include proper evidence here too

 

[Yanique1]

Schematica is allowed however the printer feature is only allowed on factions. To avoid being console banned while printing on factions, use /printer. Do not use printer on any other gamemodes as that will lead to a permanent ban.